Publicité
WARNING
option in the User Menu. To wake the Omni, the following SID
sequence is required: Left, Right, Left, Right. Note, this waking
method only works if the Omni has been put to sleep via the
User Menu. For that to work, the "Sleep 12V" parameter has to
be turned off to allow the Link to operate constantly. For safe
operation of the chair NowTechnologies does not recommend
the above-described scenario, instead please install the
Headrest Sensor within the reach of the User that can act as
an emergency stop as well. For more instructions, see the
"Headrest and Headrest Sensor" section.
Please make sure that your R-Net configuration meets the following
criteria:
• The correct SID port is configured as proportional.
• Sleep 12V parameter is set.
• User control is set.
• Drive, Acceleration and Deceleration settings are at a comfortable and
safe level.
The Omni can be put to sleep by selecting that
62
Publicité
