Animo A140 Mode D'emploi page 7

The following points should be observed
when wiring a new plug:
1. The green/yellow-coloured wire
("EARTH") should be connected to the
terminal which is either marked with the
letter "E", the "earth" symbol (
coloured green or green/yellow.
2. The blue-coloured wire ("NEUTRAL")
should be connected to the terminal which
is either marked with the letter "N" or
coloured black.
3. The brown-coloured wire ("LIVE")
should be connected to the terminal which
is either marked with the letter "L" or
coloured brown.
IMPORTANT !
The three core mains cable (fig. 2) has the
following wiring code:
Green/Yellow - Earth
Blue - Neutral
Brown - Live
WARNING !
* Make sure that the mains cable does not
come into contact with the hot plates
which become extremely hot when is use.
* Always remove the plug from the socket if
the machine has to be opened for repair
or maintenance.
* Do not position the machine in areas
where the temperature drops below
freezing point because there is always
water left in the system.
* Always plug the machine into an earthed
wall socket.
* Do not submerge or spray the machine.
* Have all repairs carried out by a specially
trained technician.
* If the machine is not used it is advisable
to remove the plug from the socket.
09/98
), or
Green/Yellow - Earth (E)
Blue - Neutral (N)
Brown - Live (L)
fig. 2
4 CONTROL PANEL
A - Orange alarm lamp
B - On/off switch for upper hot plate
C - On/off switch machine and
On/off switch for lower hot plate
5 PREPARATIONS BEFORE USE
Before operating the machine, carry out the
following steps:
1. Pour a jug of cold water in the cold water
reservoir (fig. 1E).
2. Wait for 3 minutes until the water has
entered the entire system.
3. Slide the removable filter into the machine
and place an empty jug on the lower hot
plate.
4. After you have followed the instructions
above, place the plug in the socket and
turn the machine on using the main switch
(fig. 3C) .
5. The orange alarm lamp (fig. 3A) on the
filter coffee unit will now light up until the
machine has emptied. When the light
goes out again the coffee unit is ready for
use.
6. In case the ight does not light up, there
will probably be some air inside the
system. Check the supply down in the
water reservoir, the might be some
airbubbles in side. In that case the have to
removed with, for instance, a pencil.
5
English
A B C
fig. 3
fig. 4
A 140