Samsung DVD-HR738 Manuel D'instructions page 24

Connecting HDMI/
DVI to a TV (HR738 Only)
If your TV has a HDMI/DVI input, connect HDMI/DVI
Adapter cable to a TV. You will enjoy the best quality
images and sounds.
• Case 1 : Connecting to a TV with HDMI Jack
• Case 2 : Connecting to a TV with DVI Jack
Case 1 : Connecting to a TV with
HDMI Jack
• Using the HDMI cable connect the HDMI OUT
jack on the rear of the HDD & DVD RECORDER to
the HDMI IN jack of your TV.
• Press the input selector on your TV remote control
until the HDMI signal from the HDD & DVD
RECORDER appears on your TV screen.
< DVD-HR738 >
24 - English
Case 2 : Connecting to a TV with
DVI Jack
• Using the DVI Adapter Cable(not supplied),
connect the HDMI OUT jack on the rear of the
HDD & DVD RECORDER to the DVI IN jack of
your TV.
• Using the audio cables, connect the AUDIO
(red and white) OUT jacks on the rear of the HDD
& DVD RECORDER to the AUDIO (red and white)
IN jacks of your TV. Turn on the HDD & DVD
RECORDER and TV.
• Press the input selector on your TV remote control
until the DVI signal from the HDD & DVD
RECORDER appears on your TV screen.
To use HDMI cable, make the Audio/Video
I
connection before plugging in the power cord
CAUTION
or after finishing the "Plug & Auto Setup."
Do not connect the HDMI cable while the
"Plug & Auto Setup" is progressing.
Progressive scan automatically activates when
I
HDMI is connected.
If your TV does not have Bitstream decoder,
I
you must set the digital audio output to PCM in
order to watch through the HDMI output.
(See pages 39~40)
Depending on the HDMI device (TV/HDMI
I
Receiver) you use, audio may not be
supported. If TV/HDMI Receiver does not
support Dolby digital, Audio output is not
available when you set Digital output as
'Bitstream' in Audio setup menu. In this case,
set the digital audio output to PCM. If TV/HDMI
Receiver does not support DTS, Audio output
is not available when you play disc in DTS
format.
You can switch from the HDMI output to other
I
output only in stop mode.