Contents Of The Product; Description Of The Product; First Use From New - Num'axes EYENIMAL 350 Guide D'utilisation

User's guide
● Contents of the product
▪
1 350 Remote Trainer receiver collar fitted with short contact points and a strap
▪
1 3-V CR2 lithium battery for the collar
▪
1 350 REMOTE TRAINER remote control fitted with a 3-V CR2430 lithium battery
▪
1 neon test lamp
▪
1 pair of long contact points
▪
1 carry strap
▪
This user's guide
● Description of the product
Continuous static corrections
limited to 8 seconds
Flash static corrections
shorter than 1 second
Adjustment of the level of the
static corrections
Beeper button
Indicator of radio
transmission
Battery level indicator
● First use from new
 Fitting the battery in the receiver collar
▪
Unscrew the 4 screws of the top of the collar using a screwdriver.
▪
Insert the battery (3V Lithium CR2) paying attention to follow polarity indicated on the battery housing (ref. Diagram 4).
▪
A beep sound (low pitch) is emitted, indicating the correct installation of the battery.
If you do not hear any beep after having inserted the battery, remove it immediately from its housing. Check the polarity before trying
again.
▪
Before putting the lid back in place, check that the rubber seal is in its groove.
On/Off button
Red mark: Area
where the On/Off
switch magnet is
REMOTE CONTROL
Diagram 1
- 1 -
LCD screen
located
RECEIVER COLLAR
static corrections level indicator
LCD SCREEN
Diagram 3
2 contact points
(short or long)
On/Off indicator
radio reception
Diagram 2
(from 1 to 9)
+
Indicator of
+
Battery level
indicator