Foreword
•
The understanding between a dog and his owner has existed since a long time.
Nonetheless, a dog is often guided by his natural instincts and breaks the rules is master has taught him, causing complaints about straying and
damages such as: damage to flowerbeds, jumps into swimming pools, etc. More seriously, he may be the victim or the cause of road accident.
The CANIFUGUE PRO/CANIFUGUE MIX pet fencing system is a modern and highly effective system enabling you to keep one or more dogs in complete
freedom within a perimeter, fenced or unfenced, you have defined.
•
Contents of the product
CANIFUGUE PRO
- rechargeable collar fitted with short contact points
- strap
- battery charger for the collar
- transmitter with power unit
- 100 m antenna wire
- connection kit including 3 antenna wire connectors and
1 transmitter connector
- set of 10 flags
- magnetic key (magnet)
- neon test lamp
- pair of long contact points
- CD-ROM
- this user's guide
•
How the pet fencing system works
You can define your dog's play area by installing a wire, called antenna wire, around the authorized perimeter. This wire placed on the ground, buried
or raised on an existing fence carries a radio signal from the transmitter.
When your dog, wearing a receiver collar, approaches this wire, he is warned by beep sounds that he is too close to an area where he is not allowed;
then if he carries on, static stimulations will be emitted by the collar. Your dog will have to leave the unauthorized area to stop the stimulations and
beep sounds.
An unlimited number of receiver collars can be used with one transmitter: you can keep as many dogs as you wish safely in the
same area.
CANIFUGUE PRO and CANIFUGUE MIX collars can be used at the same time with the same transmitter.
The CANIFUGUE PRO/CANIFUGUE MIX pet fencing system has been designed to give you complete satisfaction with an antenna wire with a maximum
length of 800 meters (equivalent to four square hectares). If a longer antenna wire is used, the pet fencing system will still work, but the warning and
stimulation zones will be markedly reduced.
•
Installing the pet fencing system
• Transmitter
The transmitter must be installed indoors in a dry location: the transmitter can withstand changes in temperature but will be damaged by water. Make
sure the transmitter is correctly and surely fixed (for example screw it to a wall).
Install the transmitter in a garage or garden shed near an electrical outlet (220 V AC).
• Antenna wire
For the system to operate, the wire must be connected to the transmitter and form a continuous loop from the transmitter and back again. The outward
and inward wires must be spaced 2 meters apart to avoid cancelling the signal.
0.52 mm² or 2.5 mm² wire can be used (you can combine several wire sections).
The wire sections recommended depending on the length of the system are as follows:
− for less than 800 m of antenna wire: 0.52 mm²
− from 800 to 2 000 m of antenna wire: 2.5 mm²
From the transmitter, unroll the wire around the perimeter you wish to protect. To run the wire from your garage or garden shed, pass it through a
window, door or similar.
The wire can be placed on the ground, buried (maximum: 10 cm deep) or fixed to a non-metallic existing fence or wall (best height: your dog's neck
height). If you plan on burying the wire, make sure your installation is functioning properly before doing so. You can protect the wire by running it
through PVC pipe or a length of garden hose.
The wire must not be taut as variations in temperature may cause it to expand or contract. In the corners, do not make right angles but prefer rounded
•
Contents of the product
CANIFUGUE MIX
- collar fitted with short contact points and a nylon strap
- lithium 3 Volts CR2 battery for the collar
- transmitter with power unit
- 100 m antenna wire
- connection kit including 3 antenna wire connectors and
1 transmitter connector
- set of 10 flags
- neon test lamp
- pair of long contact points
- CD-ROM
- this user's guide
Gb - 16