Num'axes EYENIMAL 350 Guide D'utilisation page 5

▪
Screw up the 4 screws with care (do not over tighten them).
Polarity "-" of the battery
Diagram 4
 Activate/deactivate the remote control
Remote control is supplied with battery fitted.
▪
Activate: press for 1 second the On/Off red button
the LCD screen.
▪
Deactivate: press for 1 second the On/Off red button
To increase the battery life, we recommend you to deactivate the unit if you are not using it for a long period.
 Activate/deactivate the receiver collar
A magnet located in the remote control is used to either switch on/off the receiver collar.
▪
Activate: move the remote control towards the collar so that the red mark on the remote control comes into contact with the red mark
on the receiver collar, hold for 1 second (ref. Diagram 5). The indicator light on the collar will flash in green indicating that the receiver
collar is On.
▪
Deactivate: move the remote control towards the collar so that the red mark on the remote control comes into contact with the red
mark on the collar, hold for 1 second (ref. Diagram 5). The indicator light on the collar will flash from green to red and then off: the
receiver collar is Off.
To increase the battery life, we recommend you to deactivate the unit if you are not using it for a long period.
 Coding of the remote control and receiver collar
Each remote control has its own individual radio operator code. The coding of the remote control with the receiver collar enables the two units
to work together.
Polarity "+" of the battery
located on the side of the remote control (ref. Diagram.1). Indications appear on
Approach until coming in contact those 2 areas during 1 second
of the remote control (ref. Diagram.1). The LCD screen is off.
- 2 -
Seal
Diagram 5