Battery Safety - Oregon PowerNow CS250 Guide De L'opérateur

orEgoN® powerNow™
ChAiNsAW MoDEl Cs 250
danger: never Modify or
atteMpt to disaBle tHe cHain
Brake.
Make sure the chain brake is working
properly before using the chainsaw. The
hand guard should move back and forth
easily.
To test the operation of the chain brake,
perform the following steps:
• Disengage the chain brake by pulling
the hand guard towards the front
handle.
• Start the saw.
• Push the hand guard towards the front
of the saw.
A properly functioning hand brake
will stop the movement of the chain
immediately. If the chain brake is not
working properly, do not use the
chainsaw until it has been repaired by a
qualified service representative.
cHain
The saw chain in this package is low-
kickback saw chain. It met the reduced
kickback requirements of ANSI B175.1
when tested on a representative sample
of chainsaws. Replace only with genuine
PowerSharp® saw chain.
Bar
This saw comes equipped with a
guide bar that has a small radius nose.
Small radius noses generally have less
potential for kickback.
When replacing the bar, be sure to order
the bar listed in this manual.
AF 0911 - F/N 547361

Battery safety

danger: failure to folloW
tHese safety rules can
cause tHe Battery pack to
leak Hazardous cHeMicals,
overHeat, eMit sMoke, Burst,
flare, explode, and/or ignite.
• Do not disassemble or modify the
battery pack. The battery pack is
equipped with built-in safety and
protection features which may be
inadvertently disabled.
• Do not connect the positive (+) and
negative (-) terminals with metal
objects. Do not transport or store
the battery pack together with metal
objects such as coins or screws. Short-
circuiting may occur or the metal object
in contact with the battery pack can
generate heat.
• Do not discard the battery pack into
fire or otherwise expose to excessive
heat. Such conditions can cause the
insulation to melt or safety features to
be damaged.
• Do not use, charge, or store the battery
pack near a heat source as fire or a
heater that generate temperatures
above 176°F (80°C). Overheating and/or
internal short circuiting may occur.
• Do not immerse the battery pack in
water or expose it to extremely wet
conditions. Moisture can cause the
protective features to be damaged,
resulting in charging with extremely
high current and voltage, which may
lead to abnormal chemical reactions.
• To recharge the battery pack, use the
battery charger specifically designed
for the battery pack and observe the
specified charger safety precautions
detailed in this manual. Failure to
do so may result in extremely high
current and voltage, which may lead to
abnormal chemical reactions.
SAFETY RULES
9