Operating The Saw; Battery Pack And Charger - Oregon PowerNow CS250 Guide De L'opérateur

orEgoN® powerNow™
ChAiNsAW MoDEl Cs 250

operating tHe saW

Battery pack and cHarger

Battery pack led cHarge-level
indicator
The lithium ion battery pack is equipped
with an LED charge-level indicator. To test
the charge level of the battery pack, press
the indicator button on the battery pack's
face (Fig. 6).
No lights: recharge.
One steady green light:
less than 25% charged. CHARGE
BATTERY PACK BEFORE USE.
Two steady green lights:
26-50% charged.
Three steady green lights:
51-75% charged.
Four steady green lights:
76-100% charged.
Fig. 6
INDICATOR BUTTON
INDICATOR LIghTS
connecting tHe cHarger
Connect the charger cord to the charger
and to the proper electrical outlet
(Fig. 7).
Fig. 7
AF 0911 - F/N 547361
Only use the cord set that was supplied
with the charger. At first use, verify that
the plug type matches the receptacle.
cHarger led cHarge-state
indicator
The battery charger is equipped with an
LED charge-state indicator that alerts
you to the state of charging, as well as
conditions that may delay or prevent
charging (Fig. 8).
Note: Until a battery pack is inserted, no
lights will be visible.
Blinking orange light: a fault
condition exists. There are
several potential causes. See
Troubleshooting in this manual.
Steady orange light: the battery
pack temperature is beyond
the acceptable range (32°F/0°C
to 104°F/40°C). ALLOW THE
BATTERY PACK TO REACH THE
ACCEptAblE tEMpErAtUrE
RANGE BEFORE CHARGING. The
pack may be left on the charger
As thE tEMpErAtUrE ADJUsts .
Charging will begin when the
proper temperature is reached.
Fig. 8
Blinking green light: battery pack
is charging.
Steady green light: battery pack
rEADy For UsE .
OpERATINg ThE SAW
17