Battery Safety - Oregon CS250 Manuel D'instruction

SAFETY RULES
STORING THE CHARGER
• Remove battery pack from the charger
• Disconnect charger from power source
• Store in a dry place
• Keep out of reach of children or pets
See "Maintenance and Cleaning" for more
information
TRANSPORTING THE CHAIN SAW
Remove the battery pack from the saw
and install the blade cover Clean the saw
thoroughly and if desired, drain the bar
and chain oil to reduce seepage
TRANSPORTING THE BATTERY PACK
Observe respective national regulations
when shipping lithium ion batteries,
compulsory labeling may be required
CHAIN SAW AND CHARGER DISPOSAL
The OREGON® product is designed
and manufactured with high quality
materials and components which can
be recycled and reused Upon product
end-of-life, and according to Directive
2002/96/EC, the electrical appliance
should be disposed of separately from
household waste In the European Union
there are separate collection systems for
used electrical and electronic products
Please dispose of this equipment in
an environmentally correct manner at
your local community waste collection/
recycling centre
BATTERY PACK DISPOSAL
Do not dispose of battery pack in normal
household waste Do not incinerate
battery pack Local waste management
and recycling agencies have information
on proper disposal or recycling according
to environmental regulations
12
OREGON® CORDLESS TOOL SYSTEM
CHAIN SAW MODEL CS250

BATTERY SAFETY

DANGER: FAILURE TO FOLLOW
THESE SAFETY RULES CAN
CAUSE THE BATTERY PACK TO
LEAK HAZARDOUS CHEMICALS,
OVERHEAT, EMIT SMOKE, BURST,
FLARE, EXPLODE, AND/OR IGNITE.
CAUTION: DO NOT DISPOSE
OF THE BATTERY PACK IN THE
HOUSEHOLD WASTE OR FIRE.
LITHIUM ION BATTERY PACKS
SHOULD BE RECYCLED BY LOCAL
AUTHORISED RECYCLER.
CAUTION: DO NOT EXPOSE
BATTERY PACK TO EXCESSIVE
HEAT, SUCH AS THE INTERIOR OF A
VEHICLE IN HOT WEATHER. SUCH
EXPOSURE CAN CAUSE A LOSS
IN PERFORMANCE AND/OR ITS
SERVICE LIFE SHORTENED. DO NOT
ATTEMPT TO RE-CHARGE A NON-
RECHARGEABLE BATTERY PACK.
• Do not disassemble or modify the
battery pack The battery pack is
equipped with built-in safety and
protection features which may be
inadvertently disabled
• Do not connect the positive (+) and
negative (-) terminals with metal objects
Do not transport or store the battery
pack together with metal objects such
as coins or screws Short-circuiting may
occur or the metal object in contact
with the battery pack can generate heat
• Do not discard the battery pack into
fire or otherwise expose to excessive
heat Such conditions can cause the
insulation to melt or safety features to
be damaged
• Do not use, charge, or store the battery
pack near a heat source as fire or a
heater that generate temperatures
above 80°C (176°F) Overheating and/or
internal short circuiting may occur
AD 0213 - F/N 551309