MBM 77T-M1 Manuel D'installation Et D'utilisation page 49

TROUBLESHOOTING
Whenever the appliance does not work properly, try to solve the less seri-
ous problems using this table.
FAULT
Insufficient heating of co-
oking zone
Continuous heating of
cooking zone at maximum
power
Empty cooking zone starts
operating
Small metal objects are
heated
No heating of cooking zone
No reaction of appliance
Fuses blow when
switching on
High generator temperature
Cooking zone temperature
sensor intervention on
If the problem cannot be resolved, turn the appliance off and shut all the
supply valves. Then contact authorized customer service.
THE PRESENT MANUAL IS PROPERTY OF THE MANUFACTURER. ANY REPRODUCTION, EVEN PARTIAL, IS PROHIBITED.
POSSIBLE CAUSE
Unsuitable pan material (eg
aluminum)
Knob switch faulty
Pan detection faulty
Pan detection faulty
Pan bottom Ø less than 12
cm //
Generator defective
Mains fuse / main supply in-
terrupted
Air filter to be cleaned /
changed
Empty pan
- 23 -
MAINTENANCE
INTERVENTION
Use suitable pan material
(see. chap. Instruction - Lo-
ading/Unloading)
Call technical authorized
service
Use suitable pan material
(see. chap. Instruction - Lo-
ading/Unloading) /
Call technical authorized
service
Clean / Change air filter
Turn the knob to "zero"/ Re-
move pan, switch off and
wait for the hob to cool down
/ Call technical authorized
service