MBM 77T-M1 Manuel D'installation Et D'utilisation page 46

ERROR FAULT
LIN versions of
17
devices incom-
E1 →
patible
18
E1 → Internal error
19
Internal error
E1 →
Error in pot de-
20
tection configu-
E1 →
ration
CAN bus shut-
23
E1 →
down error
IGBT temperatu-
26
E1 →
re >140 °C
ERROR CODES FROM THE DIGITAL CONTROLS (E2)
ERROR
02
Potentiometer integrity
E2 →
Double-Sided control lost One of Double-Sided no-
03
E2 →
LIN Bus connection open No communication de-
05
E2 →
06
LIN Bus conflict
E2 →
- Interrupted iring
10
E2 →
- Incorrect ID
THE PRESENT MANUAL IS PROPERTY OF THE MANUFACTURER. ANY REPRODUCTION, EVEN PARTIAL, IS PROHIBITED.
CAUSE
LIN Knob with old firmware Use LIN Knob with firmware
Internal error inside MOD1
Generator
Internal error inside MOD1
Generator
Pot detection has not been
done properly
CAN bus has been shut
down due to an fatal error
of another
component
Ambient temperature too
high
Fat filter or vents blocked
Fan blocked or defective
FAULT
Damaged potentiomete
des damaged
tected
Conflict ID
Connection fault betwe-
en keyboard and gene-
rator
The digital control has an
incorrect ID
- 20 -
MAINTENANCE
INTERVENTION
F120.0.1.0 or above
Contact customer support
Contact customer support
Repeat pot detection adjust-
ment
Check the other components for
error codes and fix the other oc-
curred errors at first
Allow generator to cool down;
reduce ambient tem-perature
Check fat filter and vents
Check fan; replace fan
CAUSE
Call technical authorized
service
INTERVENTION
8.
EN