Publicité
6- L
IV - Modification to cabinet layout
To change the position of a sliding shelf, first of all completely unload the shelf. Then lift the sliding shelf and slid it towards you whilst holding the front of
it upwards. Remove the wall slider guides, marking which is right and which is left, then reinstall them as shown below:
Wall
Guide
Wall
Guide
Then replace the sliding shelf as shown opposite:
7 - C
1- Connection
Check that the plug is connected to a power supply (presence of correct amp fuses, functioning
30 mA* differential circuit breaker (*not applicable to certain countries).
Make sure you wait 48H before commissioning.
Do not use an extension cord or multi-socket with this appliance.
I1- Switching on
Press and hold down the U button located on the setting panel until the display is activated.
When the temperature setting function is starting up, the message "OD" will appear. When this
occurs, please wait for the temperature to be displayed and do not touch any of the control buttons
or unplug the appliance.
10
– S
AYOUT
Installing the rear section
of the guide
Sliding shelf
Guide
OMMISSIONING YOUR WINE CABINET
TORAGE
Installing the front section
of the guide
Guide
Guide
Wall
U
P
Wall
Publicité
