Publicité
5 - I
II - Alternative hanging of solid door
a - Parts summary
1 - 2: Grommets
3:Torx screws 25
4: upper hinge
5: spacer
6: lower hinge
7: door catch
b - Alternative hanging of solid door
Your wine cabinet door is reversible, therefore you can change
which way it opens.
• Close the door
• Remove the grommets, see Fig.A.
• Remove the torx screws and the upper hinge.
• Lift and take off the door and put it to one side
• Carefully set down your wine cabinet onto its side. (The side
where the flexible cable is attached).
• Unscrew the cylinder bases on the grid side (front side) Fig. B.
• Fit the spacer and the lower hinge using the torx screws 25 on the
opposite side (see Fig. C) and position it according to the guidelines
in Fig.D
• Screw down the cylinder bases.
• Stand the cabinet upright.
• Dismantle the door catch by removing the Phillips screws, see Fig.E
• Reassemble the door catch on the opposite side.
• Position the door onto the pin of the lower hinge. Hold the door
against the door seal.
• Place the pin of the upper hinge in the corresponding slot of the
door.
• Fit the 3 screws. Ensure that the hinge is fixed properly into place,
if not adjust it. See Fig.F.
• Fit the 3 grommets.
• Put your wine cabinet back in its vertical position
• Wait 48 hours before switching on
Fig.D
8
NSTALLING YOUR WINE CABINET
Fig.E
2
7
Fig.A
Fig.B
Fig.F
1
5
3
4
Fig.C
6
Publicité
