Publicité
III - Modification to cabinet layout
To change the position of a sliding shelf, first of all completely unload the shelf. Then remove the sliding shelf by sliding it towards you whilst at the same
time lifting the front section. Remove the wall slider guides, marking which is right and which is left, then reinstall them as shown below:
Wall
Guide
Wall
Guide
Then replace the sliding shelf as shown opposite:
7 - C
1- Connection
Check that the plug is connected to a power supply (presence of correct amp fuses, functioning
30 mA* differential circuit breaker (*not applicable to certain countries).
Make sure you wait 48H before switching the cabinet on.
It is not recommended to use a multi-socket or extension lead.
II- Switching on
Press the on/off button located on the control panel on the left hand side
6- L
Installing the rear part
of the guide
Sliding shelf
Guide
OMMISSIONING YOUR WINE CABINET
– S
AYOUT
Installing the front part
of the guide
Guide
TORAGE
Guide
Wall
Wall
11
EN
Publicité
