Publicité
5 - I
II - Door reversibility
a - Parts summary
1 - 2: Grommets
3: Torx screws 25
4: upper hinge
5: spacer
6: lower hinge
7: door catch
b - Door reversibility
Your wine cabinet door is reversible. In this way you can change
which way it opens.
• Close the door
• Remove the grommets, see Fig.A.
• Remove the torx screws and the upper hinge.
• Lift and take off the door and put it to one side
• Carefully set down your wine cabinet onto its side. (The side
where the flexible cable is attached).
• Remove the screws, lower hinge and spacer, see Fig.B.
• Fit on the opposite side: the spacer and the lower hinge using the
torx screws, see Fig. C, and position it according to the guidelines
Fig.D
• Stand the cabinet upright.
• Dismantle the door catch by removing the screws, see Fig.E
• Reassemble the door catch on the opposite side.
• Position the door onto the pin of the lower hinge. Hold the door
against the door seal.
• Place the pin of the upper hinge in the corresponding slot of the
door.
• Fit the 3 screws. Ensure that the hinge is fixed properly into place,
if not adjust it. See Fig.F.
• Fit the 3 grommets.
• Put your wine cabinet back at a vertical positions
• Wait 48 hours before plugging in
Fig.D
8
NSTALLING YOUR WINE CABINET
Fig.E
2
7
Fig.A
Fig.B
Fig.F
1
5
3
4
Fig.C
6
Publicité
