Publicité
Les langues disponibles
Les langues disponibles
4
5
Connect the supplied antennas.
Connect the FM antenna to the FM 75 !2 terminals and the
AM antenna to the AM LOOP terminals.
FM antenna
Connect the AC cord to an AC outlet.
Do not short-circuit the 0 and 0 speaker cord leads; otherwise
the sound may become inaudible or the system may be turned
off. if this happens, disconnect the AC cord from the AC outlet
and re-connect the speaker cords correctly. Connect then the
AC cord and turn the system on again.
To stand the AM antenna on a surface
Fix the claw to the slot.
To
position
the
antennas
FM feeder antenna:
Extend this antenna horizontally in a T-shape and fix its ends to
the wall.
AM loop antenna:
Position to find the best direction.
m
Do not connect any speakers to the system other than the
supplied ones.
Do not leave objects generating magnetism near the speakers.
Do not bring the FM antenna near metal objects or curtain rails.
Do not bring the AM antenna near other optional equipment,
the stereo system itself, the AC cord or speaker cords, since
noise will be picked up.
Do not unwind the AM antenna wire.
CONCERNING
THE DISPLAY WINDOW'S
DEMO DISPLAY
When the power cord is plugged into an electrical outlet for the
first time after purchase, a demo display will appear in the display
window.
When the power is turned on, the demo display will
end. When the power is turned off, the demo display will appear
again.
Until the clock is set, the demo display will appear
whenever the power is turned off. (For setting the clock, see
page 7.)
When the clock is set
The demo display can be seen by pressing the MODE button
while pressing the SHIFT button on the remote control.
This
button is used also to dim the display and to set the system in
the power economizing
mode.
See page 7 for detailed
explanation.
PLACING THE TWO UNITS SIDE BY SIDE
You may also place the CD/tape and the tuner/amplifier
units
side by side according to your preference.
In this case, make sure that the flat cable does not obstruct the
ventilation openings, as shown below.
Always leave adequate clearance between the flat cable and the
ventilation openings.
CONNECTING
AN OUTDOOR ANTENNA
For better
FM reception,
use of an outdoor
antenna
is
recommended.
Connect the outdoor antenna to the FM 75 K2terminals.
\ To connect other optional equipment+
page 20.
]
ENGLISH
5
Publicité
