Aiwa XR-M88 Mode D'emploi page 4

CONNECTIONS
2 Connect the speaker cords to the speakers.
Connect the cords with the white stripes to @ terminals and
the other cords to @ terminals.
Before connecting the AC cord
The rated voltage of your system shown on the bottom of the
tuner/amplifier unit is 120 V AC. Check that the rated voltage
matches your local voltage.
IMPORTANT
Connect the speakers, antennas, and all optional equipment
first. Then connect the AC cord.
There are no differences between the front speakers. Both
3 Connect the speaker cords to the tuner/amplifier
speakers can be connected as L (Left) or R (Right).
unit.
1 Place the CD/tape unit on top of the tuner/
The cords with the white stripes should be connected to the
amplifier unit and plug in the connector of the
~
terminals and the other cords to the 0 terminals.
flat cable as shown below.
Note that the connector can be plugged in in only one direction
d
with the flat cable facing left.
\
F=:% ,:!
e\
?
~ @ ~,zE~'
/
@ "5P
.'
t cable
unit
After plugging in the connector, allow adequate clearance
between the flat cable and the ventilation openings.
FM antenna
4
ENGLISH