Aiwa XR-M88 Mode D'emploi page 15

BASIC RECORDING
9
II
REC
FUNCTION
t
a
—..... —
1
0
Cassette
,.. - .-... —
\u
deck
$ $
c1
CD
TUNER/
BAND
Q
SHIFT I II
RECI
REC MUTE
Preparation
Set the ta~e to the ~oint where recording will start.
*I
TAPE
Use Type I (normal) and Type II (high/C rO-2) t apes for recording.
1
2
3
4
Load the tape to be recorded on into the deck.
Load the tape with the side to be recorded on first facing
upward and the exposed side facing to the right.
I
r- 1
~
0
Press the TAPE button on the remote control to
select the reverse mode.
To record on one side only, select Z.
To record on both sides, select 1) or (=1.
When recording is started from the side facing downward,
the tape stops at the end of recording of this side, even if the
reverse mode is set to =) or C=).
Press one of the function buttons and prepare
the source to be recorded.
To record from a radio broadcast, press the TUNER/BAND
button on the remote control and tune in to a station.
To record from a CD, press the CD button on the remote
control and load a CD.
To record from equipment connected to the AUX IN jacks
or the MD IN jacks, press the AUX/MD button repeatedly to
display "AUX or "MD respectively, and prepare the equipment
for playback.
Press the REC button on the CD/tape unit to
start recording.
To
start recording with the remote control, press the REC/
REC MUTE button and within 2 seconds, press the > button.
When recording from a CD, playback and recording start
simultaneously.
When recording from connected equipment, start playback.
To stop recording, press the g button. When recording from a
CD, press the button again to stop playback.
To pause recording, press the II button. (Applicable when
recording from a radio broadcast or connected equipment.) To
resume recording, press again.
INSERTING BLANK SPACES
Insertion of 4-second blank spaces may help you to locate the
beginning of the track when the tape is played back on other
equipment. (Applicable when the source is radio or connected
equipment.)
1 Press the REC/REC MUTE button on the remote control
during recording or while in recording pause mode.
"TAPE ~" flashes rapidly for 4 seconds and the tape runs
without recording. After 4 seconds, the deck enters the
recording pause mode.
2 Press the 1I button to resume recording.
To insert a blank space of less than 4 seconds, press
the REC/REC MUTE button again while "TAPE ~" is
flashing rapidly.
To insert blank spaces of more than 4 seconds, after the deck
enters recording pause mode, press the REC/REC MUTE
button again. Each time the button is pressed, a 4-second blank
space is added.
To erase a recording
1
2
3
4
Load the tape to be erased into the deck.
Set the tape to the point where the erasure is to be started.
Press the AUX/MD button on the remote control, or press
repeatedly the FUNCTION button on the CD/tape unit so that
"AUX is displayed.
If an optional equipment is connected to the AU)( IN jacks,
turn it off.
Press the REC button on the CD/tape unit to start the
erasure.
ENGLISH 15