Installation Steps; Electrical Preparation - Scrigno Antamatic Open 2.0 Manuel D'installation

EN

INSTALLATION STEPS

The motor must be installed in the rail head where the door opening upright is located.
G
Remove the door, the hangers and the upright (if fi tted), before starting to install the kit
Motor

ELECTRICAL PREPARATION

H
Caution: the electrical preparation operations
must only be performed by
skilled personnel
Position the junction box in an accessible position, in the
door closing upright area, making sure that the motor
cable length is su cient.
The cable may not be extended or spliced!
Note: The cable outlet position may di er
from the one shown alongside.
Avvitare, senza serrare a fondo, la vite di
1
2
Remove the rear block.
fi ssaggio della puleggia, rispettando la misura
minima di 30mm.
Motor cable
OPENING CLOSING
30mm
Radar detector
(optional)
Electronics
MOTOR CABLE INLET
PG CONNECTOR for BUTTON
CABLE (not supplied)
230V POWER CABLE
1a
DOORTECH version:
Remove both blocks and replace them with
those for the Doortech version.
Fit the front block back on.
Open
2.0
Pushbuttons
(optional)
230V
Bipolar
Switch
R1387 DCM2461/SCRIGNO | page 5