Scrigno Antamatic Open 2.0 Manuel D'installation page 59

EN
21
Tighten the belt by hand.
23
This picture shows the correct end result.
!
HOW TO TENSION THE BELT CORRECTLY
At about 20 cm from the pulley, tighten the two ends of the belt between
your thumb and the little fi nger of your hand. The belt is correctly
tensioned if, with little e ort, you can make them touch each other.
20cm.
Pulley
A belt which is too tight will be noisy, cause high power consumption
and can a ect the proper operation of the system.
A belt which is too slack tends to jump over the gears.
Periodically check the belt for wear and tension.
Periodically use silicone spray if it becomes noisy.
Do not use detergents, solvents, rust sprays, or products such as
Svitol ® or WD40 ® .
Pass the belt fl ap through the two free slots of the
22
junction bracket, locking it in place.
Cut o the excess part of the belt
24
Adjust the belt tension by screwing or unscrewing
the bolt (A) with the Allen wrench.
IMPORTANT! The pulley must be free to move!
25
Belt
Open
A
After completing the operation,
tighten the bolt (B).
B
R1387 DCM2461/SCRIGNO
2.0
| page 11