Hürner CNC ECO 160 Manuel Utilisateur page 37

H Ü R N E R S c h w e i s s t e c h n i k G m b H
Nieder-Ohmener Str. 26
35325 Mücke, Germany
Menu Item Setting
Pipe Length ON / OFF
Weather Conditions ON / OFF
Installing Company
Print Tags
All data that are available in the chip of a transponder card
can be entered by placing the card in front of the card reader.
Optionally, if they are encoded in a bar code, they can be
read using a scanning pen or a handheld scanner.
Info
4.3 Entering Traceability Data
If the machine is configured to request the input of traceability data
related to the welding, such as commission number and welder iden-
tification code, then the screens for entering these data are shown
before Display 4 appears (see Display 7). The same displays can be
accessed through a list that opens after the  cursor key was pressed.
The input of these data uses either the alphanumeric keypad (see
also the Info message in Section 4.2) and then they are confirmed by
pressing the START/SET key, or they are read from a transponder card.
4.4 Entering Pipe or Fitting Parameters
From the "open" position of the machine (see Sect. 4.1 and Display 4),
possibly after traceability data were entered, the parameters for the
components to be jointed are shown (see Display 8), which can be
confirmed or changed.
To confirm that the parameters on the display should be used for the
next welding, press the START/SET key, to change them, press STOP/
RESET to select the material of the parts to be welded (see Display 9)
or the cursor key ñ to enter the component diameter and wall thick-
ness (see Display 10). To select a material use the ñ and ò cursor
keys and confirm your selection by pressing the START/SET key. The
machine then moves on to pipe diameter/wall thickness input screen
(see Display 10) as well.
It is possible to switch back and forth between the pipe material and
the diameter/wall thickness screen without making any changes, by
pressing the ñ key.
The sub-menu that can be accessed at "Specialty Materials" allows the
selection of non-standard materials, which frequently are proprietary,
e.g., Wavin Safetech. As opposed to standard materials, specialties do
not allow the selection of all nominal pipe diameters or SDR values,
but only those that are actually available with that material. If a sep-
cialty material is selected, the diameter and the standard dimension
ratio (SDR) have to be entered in all cases, as they will not be applied
by the machine from the last completed welding operation.
The specialty material screens include a menu option "Stan-
dard Material" to enable returning to the screen in which
they were selected, the screen reproduced in Display 9.
Info
Version February 2018
if ON: the length of both pipes that are going to be welded has
to be entered before the welding;
if OFF: the length of the pipes cannot be entered.
if ON: the weather conditions in which the welding takes place
have to be selected in a list prior to welding;
if OFF: the weather conditions will not be entered.
— M — In a sub-menu, the name of the company carrying out the
piping and installation work can be entered.
— M — In a sub-menu, a completed welding operation can be selected
to print off once more to label tag belonging to it.
HÜRNER CNC ECO 160 User's Manual
Description / Possible Data
Enter Welder Code
++++++++++++++++++++
++++++++++
Display 7
PE-HD
Pipe Diameter:0250mm
Wallthickness:22.7mm
ESC SDR 11.0 ENTER
Display 8
SELECT PIPE MATERIAL
>PE80
PP
Specialty Mater.-M-
Display 9
ENTER PIPE DIMENSION
Pipe Diameter:0250mm
Wallthickness:22.7mm
Display 10
EN
15