Hürner CNC ECO 160 Manuel Utilisateur page 36

Menu Item Setting
Check Code Expiry ON / OFF
Angle ON / OFF
Welder Code
Options
Language
Time/Date
Buzzer Volume
Temperature Unit
Pressure Unit
Inventory Number
Number of Labels
Standard
In the "Report Generation" sub-menu of the Configuration Menu, the
following parameters can be set:
Menu Item Setting
Welder Code ON / OFF
Commission Number ON / OFF
Joint/Weld Number ON / OFF
Additional Data ON / OFF
Fitting Code ON / OFF
Pipe Codes ON / OFF
14
EN
if ON: identification number/code of the welder who will
perform the welding has to be current and not expired (default
period of validity 2 years from code issuance), or the welding
operation cannot be started;
if OFF: number/code validity is not checked at all.
if ON: prior to the facing process, the angle for the jointing of
the components can be entered;
if OFF: the input of an angle — hence, an elbowed joint — is
impossible.
— M — In a further screen, it can be determined when the welder code,
if it is enabled at "Recording," has to be entered:always, i. e.
before evey single welding operation, only before the first
welding operation after switching the unit on or only after the
first welding operation of a new day/date.
— M — In a further screen, the language to use for the display screen
and the printed reports can be selected.
— M — In a further screen, the time and the date of the system clock
can be set.
— M — In a further screen, the volume of the audible warning signal
can be set.
— M — In a further screen, the measurement unit used for temperature
information can be set: Fahrenheit or Celsius.
— M — In a further screen, the the measurement unit used for pressure
information can be set: bars or pounds per square inch.
— M — In a further screen, the number by which the machine/hydraulic
unit used to perform the welding is identified in the inventory
of the operating organization can be entered.
— M — In a further screen, the number of label tags to print out after a
welding operation can be selected (requires the optionally
available label tag printer).
— M — In a further screen, the welding standard to be applied to the
welding can be selected.
if ON: number/code of the welder who will perform the
welding must be entered depending on the "Welder Code
Options" value under "Settings" (see above);
if OFF: the welder code is never requested by the machine.
if ON: number/identifier of the commission to which the
welding belongs must be entered before every welding; input
of up to 32 alphanumeric characters.
if ON: joint numbers related to a given job/commission can be
assigned, and the machine automatically increments to joint
numbers by 1 for that commission (see als at the end of
Sect. 4.1).
if OFF: the joint number management is not available.
if ON: additional, user-defined data, e.g., address where the
welding is performed, can be entered before every welding;
input of up to 20 alphanumeric characters.
if ON: the code of a fitting to welded, in which the parameters
related to welding are contained, must be entered before
welding.
if ON: the code of the pipes, in which the pipe parameters
related to welding are contained, must be entered before
welding.
HÜRNER CNC ECO 160 User's Manual
H Ü R N E R S c h w e i s s t e c h n i k G m b H
Description / Possible Data
Description / Possible Data
Nieder-Ohmener Str. 26
35325 Mücke, Germany
Version February 2018