Publicité
Les langues disponibles
Les langues disponibles
RECOMMENDED CUTTING EQUIPMENT FOR CANADA
The following is a list of recommended cutting equipment for Class 1A and 1B Chainsaws.
The combinations of powerhead, bar and chain meet all requirements outlined in the CSA Z62.1-95 Chainsaws and Z62.3-96
Chainsaw Kickback standards.
The guide bar nose radius is determined by either the maximum number of teeth in the nose sprocket or the corresponding
maximum nose radius of a solid bar.
As we are listing the maximum guide bar nose radius, you may use a guide bar with smaller nose radius than in our list. For guide
bars of the same length, all sprocket-nose guide bars of the same pitch and having the same number of sprocket teeth may be
considered to have equivalent kickback energy.
A hard nose bar having the same length and nose radius as a sprocket-nose bar may be considered to have equivalent or less
kickback energy than the sprocket-nose bar.
We recommend that you as replacement use the listed bars and chains or "Type C Low-Kickback Saw Chains" which are available
at your dealer.
Bar
Length, inches Pitch, inch
13
0,325
15
0,325
16
0,325
18
0,325
20
0,325
13
0,325
15
0,325
16
0,325
18
0,325
20
0,325
Note: For the chains above you are free to choose between 0,050", 0,058" and 0,063" gauge drive link for the corresponding bar,
see the table below.
0,050"/1,3 mm
S30/95VP
0,058"/1,5mm
-
0,063"/1,6 mm
-
D
_
D
PITCH =
2
TECHNICAL DATA
Chain
Max nose radius
10T
10T
10T
Jonsered S30, Oregon 95VP
10T
10T
10T
10T
10T
Jonsered S25, Oregon 21BP
10T
12T
20BP
S25/21BP
22BP
L
– 37
Canadian
Publicité
