Kenwood AT950A Mode D'emploi page 6

Before reading, please unfold front page showing the illustrations
before using your Kenwood
attachment
Read these instructions carefully and
G
retain for future reference.
Remove all packaging and any
G
labels.
safety
Always ensure bones and rind etc
G
are removed from the meat before
mincing.
When mincing nuts only feed a few
G
down at a time and allow the scroll
to pick them up before adding any
more.
Always use the pusher supplied.
G
Never put your fingers or utensils in
the feed tube.
Warning - the cutting blade is sharp,
G
handle with care both in use and
when cleaning.
Ensure the attachment is secured in
G
position before switching on.
Do not touch moving parts.
G
Unplug the appliance before fitting or
G
removing parts or cleaning.
Refer to your main kitchen machine
instruction book for additional safety
warnings.
before using for the first time
Wash the parts see 'care and
G
cleaning'
This appliance conforms to EC
G
directive 2004/108/EC on
Electromagnetic Compatibility and
EC regulation no. 1935/2004 of
27/10/2004 on materials intended
for contact with food.
English
mincer
a
Spanner
b Ring nut
c
Mincer screens: fine, medium,
coarse
d
Cutter
e
Scroll
f
Mincer body
g
Tray
h
Pusher
i
Pusher lid
j
Dish/cover
to assemble
1 Fit the scroll inside the mincer body.
2 Fit the cutter – cutting side
outermost
properly – otherwise you could
damage your mincer.
3 Fit a mincer screen
over the pin.
Use the fine screen for raw meat;
G
fish; small nuts; or cooked meat for
shepherd's pie or meat loaves.
Use the medium and coarse screens
G
for raw meat; fish and nuts.
4 Loosely fit the ring nut.
to use the mincer
1 Pull the catch
slow speed outlet cover
2 Hold the catch back and insert the
mincer. Turn it both ways until it
locks into place.
3 Tighten the ring nut manually.
4 Fit the tray
under the mincer to catch the food.
5 Thaw frozen food thoroughly
before mincing. Cut meat into
2.5cm (1") -wide strips.
6 Switch to speed 4. Using the pusher,
gently push the food through, one
piece at a time. Don't push hard
– you could damage your mincer.
4
. Ensure it's seated
. Put the notch
and remove the
.
. Put the dish/cover