Publicité
Les langues disponibles
Les langues disponibles
02
Connecting Roller Tubes
1.Gather the two long, silver tubes (A-1, A-2) and lay them in a line.
2.Insert the roller tube (A-2) into the interior end of the roller tube (A-1). If
insertion is difficult, use a mallet to tap it gently into place. Once inserted, screw
(A-A-1) it into place.
3.At this time, you will have one full-length roller, with both roller tubes connected
and screwed securely into place.
03
Connecting Front Bars
1.Gather the two long, wedge shaped tont bars (C-1, C-2) and lay them in a ine.
2 Insert the front piece (C -2) into the interior end of the front bar (C-1). If insertion
is difficult, use a mallet to tap it into place. Once inserted, screw (A-A-1) it into
place and tighten the screw nut on the bar.
A-1
A-1
A-1
C-1
7
A-2
A-2
A-A-1
A-2
C-2
EN
EN
Publicité
