Costway NP10517 Manuel De L'utilisateur page 17

2. Using a 14mm masonry drill bit, drill the first bolt hole approximately 10cm deep, as
shown in the diagram. This must be drilled through solid brick or concrete to offer the
necessary support for the awning.
3. Drill the remaining holes exactly as in step 2.
WARNING
WARNING
03
Preparing for Mounting
1.Now that all of your holes are drilled, then insert the expansion bolts.
2.It may be necessary to drive the bolts in with a wooden (or other non-metallic) mallet.
If a mallet is necessary for installation, we recommend placing the nut
on the screw (loosely) before hammering to avoid damaging the bolt
threads.
3.Make sure that the bolts are firm in place, yet let them stick out of the wall
approximately 25mm or less-enough that the wall bracket can be installed onto them.
Firmly tighten the bolts with a 19mm hex wrench. It is best to use the hex wrench with
a closed end rather than an open end to avoid damaging the nut, should it slip.
All bolt holes must be aligned vertically and horizontally to
ensure that the awning hangs straight.
Double check alignment before drilling if you are not certain.
The diameter and depth of your mounting holes must be the
same size as the expansion bolts.
17
EN