Costway NP10517 Manuel De L'utilisateur page 16

4.Now that you have a straight, centered line, measure the middle point and mark it.
This is where the middle wall bracket will be installed.
5.Take a wall bracket and place the top of it, completely level, under the line, as shown
in the diagram below. With chalk or a pencil, mark the position of all the wall brackets
and their bolt holes. Please note the distance between each wall bracket should be the
same.
Awning < 3.3m
Awning = 3.3m-4.3m
Awning= 4.4m-6m
Wall bracket
02
Drilling the Bolt Holes
1.Now that you have a straight level
line across the wall with the locations of
the wall brackets and their bolt holes
marked, you can drill holes to mount
the brackets. link's position on the front
bar outwards, as necessary.
Requires only 2 wall brackets total: one for each end of the torsion bars.
Requires 3 wall brackets total: one for each end, and one in the middle.
Requires 4 wall brackets total: one for each end, and two in the middle.
Ground
Wall bracket leveled against horizontal line
Level(horizontal line)
16
Wall bracket
C
Drill 10cm deep
EN