Costway NP10517 Manuel De L'utilisateur page 18

04
Mounting the Wall Brackets
1.Now that the bolts are
securely installed in the wall,
remove the nuts that are loosely
placed over the bolts.
2.Place a wall bracket onto one
set of bolts. This should be an
easy fit if the bolt holes are
properly aligned.
3.Once the wall bracket is
resting on the bolts, place a
washer over the bolt. Then
secure it with a nut, as shown in
the diagram.
4.The brackets MUST sit firmly on the wall. If there is any movement, you must tighten
it more.
5. Repeat this step for each of the wall brackets. Once you do this, all wall brackets will
be securely installed in place.
05
Mounting the Awning
1.Now that the wall brackets are secure and in place, it is time to install the awning onto
the brackets.
2..At least two ladders or sturdy chairs are required to install the awning.
3.Put the torsion bars on the wall brackets and tighten them with the hex screws.
4.Finally, fasten all expansion bolts.
5.Using the hand crank or a motor (if applicable), fully open your awning. The front bar
should be level.
6.Congratulations! Your awning is installed. If you are happy with the height of the front
bar (awning pitch), sit back and enjoy! If not, please read on.
Washer
18
CROSS SECTION
OF WALL
EN
EN