Costway NP10517 Manuel De L'utilisateur page 12

06
Roller Support Assembly
WARNING
1.Fix the bolt (P) on the hole of the roller
bar (A-2)on the right side. Screw it tightly.
Failure to check this could result in injury.
2.Find the inner square shaft on the roller tube. Insert this into the square hole on
the gear box (D-3) on the torsion bar.
Insert in
3.Using a mallet, knock the roller support (D) into the right end on the roller tube
(A-2). Use a wrench to tighten the screw on the roller support.
Be sure that the safety wraps holding the two front arms
are secured on the torsion bar.
Failure to check this could result in injury.
D-3
12
P
Insert in
D
EN