Electrolux EW30DS8CRSA Instructions D'installation page 13

30" DUAL FUEL SLIDE-IN RANGE INSTALLATION INSTRUCTIONS
10.2 Models Equipped with Leveling Legs
Level the range and set cooktop height before
installation in the cut-out opening.
1. Install an oven rack in the center of the oven.
2. Place a level on the rack (see Figure 14). Take
2 readings with the level placed diagonally in
one direction and then the other. Level
the range, if necessary, by
adjusting the 4 leg
levelers with a wrench
(see Figure 26).
3. Taking care to not
damage the countertop,
slide range into cutout
opening and double
check for levelness.
11.
Check Operation
Refer to the Use and Care Guide packaged with the
range for operating instructions and for care and
cleaning of your range.
Remove all packaging from the oven before testing.
11.1 Check Burner Cap Placement
Regular burner
It is very important to be sure that all surface burner
caps and burner grates are properly installed and in
the correct locations before operating the appliance.
Please note that the burner heads are secured to
the cooktop. The cooktop is not removable. Do not
attempt to remove or lift the cooktop.
To prevent flare-ups and avoid
creation of harmful by-products, do not use the cooktop
without all burner caps properly installed to insure
proper ignition and gas flame size.
Always keep the burner caps and burner grates in
place whenever the surface burners are in use. DO
not allow spills, food, cleaning agents or any other
material to enter the gas orifice holder openings.
Check and be sure the size of each burner cap
matches the size of the burner head. Check and be
sure that all round style burner caps are correctly in
place on round burner heads.
Check and be sure that all oval style burner caps are
correctly in place on oval burner heads (if equipped).
Check and be sure that all dual or twin style burner
caps are correctly in place on dual or twin heads (if
equipped).
On round style burners, the burner cap lip (Figure 15)
should fit snug into the center of burner head and be
level. Refer to figures 16 & 17 for correct and incorrect
burner cap placement.
Once in place, you may check the fit by gently sliding
the burner cap from side to side (Figure 18) to be sure
(Models with an Electric Oven and a Gas Cooktop)
Figure 14
it is centered and firmly seated. When the burner cap lip
makes contact inside the center of the burner head you
will be able to hear the burner cap click. Please note
that the burner cap should NOT move off the center of
the burner head when sliding from side to side.
Burner Cap
Burner
Head
Correct
Burner Cap
Placement
Fig. 16
Dual Flame burner (If equipped)
Remove all tapes from burner cap Be sure that the
dual flame burner caps are correctly placed BEFORE
using your cooktop.
Note: There are no burner adjustments necessary on
this cooktop.
Burner Cap
Burner Simmer
Precision Flame
13
Burner
Cap Lip
Fig. 15
Incorrect
Burner Cap
Placement
Fig. 17
Fig. 18
Figure 19
Burner
Head