Publicité
Les langues disponibles
Les langues disponibles
30" DUAL FUEL SLIDE-IN RANGE INSTALLATION INSTRUCTIONS
For models equipped with Leveling Leg
only (no leveling device):
9.5
Make sure the four leveling legs (front and rear)
are setup higher than the height of the cabinet
(shown on page 3).
9.6
Install the anti-tip bracket at
this point before placing the range at its final
position. Follow the installation instructions
on page 15 or on the anti-tip bracket template
supplied with the range.
9.7
To provide an optimum installation, the top
surface of the countertop must be level and
flat (lie on the same plane) around the 3 sides
that are adjacent to range cooktop. Proper
adjustments to make the top flat should be made
or gaps between the countertop and the range
cooktop may occur.
9.8
To reduce the risk of damaging
your appliance, do not handle or manipulate it by
the cooktop. Manipulate with care.
9.9
Position range in front of the cabinet opening.
9.10
Make sure that the cooktop which overhangs the
countertop clears the countertop. If necessary,
raise the unit by lowering the leveling legs.
9.11
Level the range (see section 9). The floor where
the range is to be installed must be level. Follow
the instructions under "Leveling the Range-
Models Equipped with Leveling Legs".
9.12
Slide the range into the cutout opening.
IMPORTANT
If Accessories Needed
Installation With Backguard
A backguard kit can be ordered through a Service
Center. The cutout depth (21¾" (55,2 cm) Min., 22
(56,2 cm) Max.) needs to be increased to 24" (61
cm) when installing a backguard
Installation With End Panel
An end panel kit can be ordered through a Service
Center.
Installation With Side Panel
A side panels kit can be ordered through a Service
Center. Install cabinet doors 32" (81,3 cm) min. apart
so as not to interfere with range door opening.
(Models with an Electric Oven and a Gas Cooktop)
/
"
1
8
10.
Leveling the Range
10.1
Models Equipped with Leveling
Device
Level the range after installation in the cutout opening.
1. Open the range drawer. The leveling screws
control the height of the rear leg.
2. Adjust the appliance legs as follows until the
underside of the cooktop (or cooktop glass) surface
is sitting level on the countertop (Figure 13).
a. To adjust the front legs, use a wrench on the
leg base and turn counterclockwise to lower or
clockwise to raise the range.
b. Remove the rear legs using a wrench on the leg
bas and turn counterclockwise until the legs are
removed from the unit. You can discard those
legs, they are only in place to solidify the unit for
the transport.
c. To adjust the rear legs, use a ratchet or
a nutdriver and turn the leveling screws
counterclockwise to lower or clockwise to raise
the range.
3. Check if the range is level by installing an oven
rack in the center of the oven and placing a level
on the rack (Figure 14).
4. Take 2 readings with the level placed diagonally in
one direction and then the other. Level the range, if
necessary, by adjusting the leveling legs.
5. If the range cannot be level, contact a carpenter to
correct sagging or sloping floor.
12
Figure 13
Publicité
