Tools Needed for the Assembly
Modelling knife
30 007 4053
Philips screwdriver (small and big)
and hex-wrench
1,5/ 2 / 2,5 mm
30 007 4023
a. Your Radio System
Please read the instructions provided with your radio system before
using it.
The servos must be set at the centre position before installation. To set
the servos at a neutral position, turn on the transmitter and receiver.
Set the trim levers in the centre position and turn off the receiver, and
then the transmitter. The servos will be in proper neutral position for
installation.
Receiver antenna
Engine throttle
servo
Instant adhesive
30 005 3339
Hexagonal wrench
30 001 3118
(only for RTR version)
Batteries for receiver
Switch
Steering servo
CARSON CV-10B Chassis NEW GENERATION
Needle nose pliers
30 007 4034
Tweezers
30 007 4003
n)
Transmitter
ON CV 10B Ch
i NEW GENERATION
Scissors
30 001 3305
Side cutter
30 007 4035
17
17
GB