Publicité
Les langues disponibles
Les langues disponibles
Mounting and installation instructions
Introduction
This section contains all necessary information for correct mounting of the dehumidi-
fier.
The electrical installation is described at the end of this section.
Placing of
CDP 75 MK II, 125 MK II and 165 can be placed in one of the following ways:
CDP 75 MK
II/125/165
Floor
Footstands
Suspension
brackets
Important
• When placing the dehumidifier, unimpeded access to the inspection door should be
• When the unit has been mounted the handles are to be fixed to the inspection door
t
Condensate outlet
The condensate outlet is located on the air inlet side. The dehumidifier is delivered with
a 0,5 m water hose which is fixed to the 3/4" screw connector using the clip delivered
with the hose. The water hose is led to a drain.
Important
• The hose from the unit to the external drainage must have a fall of at least 2%
• The drainage pipe has to be fitted with a water trap to prevent false air from getting
• As an alternative a condensate pump can be fitted at the water outlet to pump the
30
Placing
The dehumidifier can be placed directly on the floor.
Make sure that there is enough place for the drain outlet and the
water trap.
The dehumidifier can be placed on shock absorbing footstands.
The footstands are available as options on request.
The footstands are available as options on request.
When mounting the units onto a wall we recommend oscillation
dampers to be fitted between the unit and the suspension brack-
ets.
The suspension brackets are available as options on request.
ensured
in through the pipe
water to a drain
Comments
Continued overleaf
Publicité
