Servicing Procedures - Toto Neorest II Manuel D'utilisation

1) Turn the wall and power adapter
switches to the off position. Dis-
connect the LED connector from
the power adapter connector.
2) Loosen the three screws on the
lighting cover and slide the cover as
shown.
3) Replace the LED with a new one.
Attach the new LED along the cable
guides on the cover as shown.
NOTE: When attaching the LED, make
sure the upper and lower sides of
the LED are positioned correctly.
4) After the LED is attached, replace the cover using the same procedure as
in Step 2. Secure the screws and check that it is assembled securely.
5) Turn on the wall and power
adapter switches to confirm that
the LED is lighting correctly.

SERVICING PROCEDURES

Replacing the LED
4
DISCONNECT
Fixed Base
Connector
With 5 cable
Lighting (LED)
LED
LED unit
Up
Down
LED light source
Lighting Cover
guides
Cover