Installation Procedures - Toto EcoPower STD TELS10 Manuel D'installation Et D'utilisation

NOTE
5
U P
Backup Battery
ill.1
ill. 2
Mount Bracket
Nut
Install the Spout
To Install Deck-Mounted Models (ill. 4):
Secure the spout to the countertop with the
included bracket and hexagonal nut. Make sure
that the spout is mounted with the tip directed
towards the center of the basin.
INSTALLATION PROCEDURE
Install the Controller
NOTE: Before installing the product, be sure to thor-
oughly flush the supply pipes of dirt and debris. Shut off
the water supply at the stop valves after flushing.
1. See the rough-in dimension page to determine the
proper location for the controller.
2. Loosen the screw on the front of the controller cover
and pull screw to remove screw and cover.
(see NOTE)
3. Connect backup battery to controller.
NOTE: Backup Battery will require 5 min. to initial-
ize.
4. Mount the bracket on the wall. If necessary, use wall
anchors (see ill. 1).
5. From the top, place controller into the hole in the
bracket. From below the bracket, fasten the large nut
to secure the controller (see ill. 2).
IMPORTANT!
Be sure to install controller in the correct orien-
tation as shown. Otherwise, product will not
function properly.
6. Connect the water supply line to the inlet adapter
(see ill. 3).
NOTE: If using a
thermostatic valve
(sold separately),
please refer to its
installation manual
for details.
4
ill. 3
Swivel
Supply
Coupling
or
Hose
THP3237
(NOT INCLUDED)
(Sold Separately)
OPEN
Check for Leaks
Thermostatic Mixing Valve
(TLT10R/TLT20 Sold Separately)
ill. 4
Horizontal
counter top
(Section View)
Mounting
bracket
Washer
Nut
U P
CLOSE
Stop valve
Spout model
may vary.
Sensor harness
(DO NOT pinch
during installation)