Publicité
Les langues disponibles
Les langues disponibles
After 3 to 4 of your sharpening of the cutting teeth, have the saw chain sharpened in any
authorized service. They will sharpen the depth limiter as well, which provides the distance D.
6.2- Guide bar
To avoid one-side wear, turn the guide bar after each
sharpening and chain change.
Regularly check whether the guide bar is not damaged.
Remove any possible coating.
On Quick Tension, it is necessary to reposition the quick
tensioning device at the guide bar prior to reversing.
1- Properly clean the bar grooves (see 1 in Fig.15) and the
hole for oil supply (see 2 in Fig.15).
2- Properly clean the hole for lubrication (see 1 in Fig.16) on
the tip of the guide bar (from both sides).
3- Press as much lubrication to the holes using the lubrication
press on both sides until the lubrication runs out on the tops of
the turner equally. Turn the turner at the same time.
6.3- Inner Sprocket Cleaning
After any use of the chainsaw, clean the saw properly.
1- Unscrew the chain wheel cover.
2- Clean the inner interior with the little brush.
3- Remove saw chain and guide bar.
4- Check for cracks and for excessive wear interfering with the chain drive. If the wear is
considerable, replace sprocket with new one.
5- Never fit a new chain on a worn sprocket, or a worn chain on a new sprocket.
6.4- Carbon Brush Replacement
To replace the carbon brush, open the black cover on both sides of
motor housing by tool.
Take out the carbon brush holder and replace carbon brush.
Re-install the carbon brush holder.
Close and tight motor housing cover.
6.5- Cleaning
Clean plastic parts with a soft clean cloth.
Do not use aggressive cleansers (solvents or abrasive cleansers), or an abrasive sponge nor sharp
objects.
Do not put or immerse product in water or any other liquid.
Clean ventilation holes with a soft brush.
6.6- Transport
Fig.15
Fig.16
Fig.17
Publicité
