Publicité
Les langues disponibles
Les langues disponibles
1- Connect power cable to extension cord
2- Attach the extension cord to the cable holder (9) to prevent any damage from inadvertent excessive
force pulling (see Fig.9).
3- Connect extension cord to mains power source.
4- Hold chainsaw with left hand on front handle and right hand on back handle.
Note: Maintain a firm grip, with thumbs and fingers encircling the chainsaw handles (see Fig.10)
Chainsaw with Quick Tension
Fig.9a
5- To start the engine (Fig.11):
- Press the lock button (5) with your thumb and hold it down.
- Press the ON/OFF trigger switch (6) and hold it down
- Release the lock button (5) (*)
6- To stop the chainsaw
- Release the ON/OFF trigger switch (6)
(*)
It is not necessary to keep the lock button (5) depressed after the start of the chainsaw.
The lock button is intended to prevent any inadvertent starting of the chainsaw.
V. OPERATION
5.1- Before starting
WARNING
- Before proceeding to your job, read the "Safety" section..
- It is recommended to first practice sawing easy logs. This also helps you get
accustomed to your machine.
- Always follow the safety regulations.
- The chain saw must only be used for cutting wood. It is forbidden to cut other types of
material. Vibrations and kickback vary with different materials and the requirements of
the safety regulations would not be respected.
- Do not use the chain saw as a lever for lifting, moving or splitting objects.
- Do not lock it over fixed stands.
- It is not necessary to force the saw into the cut. Apply only light pressure while running the engine
at full throttle.
- When the saw chain is caught in the cut, do not attempt to pull it out by force, but use a wedge or a
lever to open the way.
- Check that the power supply (voltage and amperage) corresponds with the specifications on the
machine. Connect machine to mains power.
- Before starting work, always check the condition of the chain, to work safely.
- Check the oil level is sufficient. If the oil level is down to about 5 mm from the lower scale, it is
imperative to add oil. If the level is above this scale, you can start work.
- Check that the lubrication mechanism of the chain is working properly (see 4.11):
- Check the chain tension, and its attachment (see "chain tension).
Chainsaw with Tool Tension
Fig.9b
Fig.10
Fig.11
Publicité
