Publicité
Les langues disponibles
Les langues disponibles
x
x
1
If necessary cut
the adhesive sealing
strip and then apply it
to the appliance as
shown in figure.
4mm
44mm
3
Adjust the appli-
ance in the niche.
Make sure that the
distance between the
appliance and the
cupboard front-edge
is 44 mm.
The lower hinge cov-
er (in the accessories
bag) makes sure that
the distance between
the appliance and the
kitchen furniture is
correct.
Open the door. Put
the lower hinge cover
in position.
www.zanussi.com
All manuals and user guides at all-guides.com
2
1
2
Install the appli-
ance in the niche.
Push the appliance in
the direction of the
arrows (1) until the
upper gap cover
stops against the
kitchen furniture.
Push the appliance in
the direction of the
arrows (2) against the
cupboard on the op-
posite side of the
hinge.
I
I
4
Attach the appli-
ance to the niche with
4 screws.
5
Remove the cor-
rect part from the
hinge cover (E).
Make sure to remove
the part DX, in the
case of right hinge,
SX in opposite case.
G H
Connect the appli-
ance laterally to the
kitchen furniture side-
wall:
7
Loosen the
screws of the part
(G) and move the
part (G) till the furni-
ture sidewall.
Tighten the screws of
the part (G) again.
Attach the part (H) to
the part (G).
C
D
E
E
B
6
Attach the covers
(C, D) to the lugs and
the hinge holes.
Install the vent grille
(B).
Attach the hinge cov-
ers (E) to the hinge.
Ha
Hb
Hc
Hd
8
Disconnect the
parts (Ha), (Hb), (Hc)
and (Hd).
25
Publicité
