Stihl RMA 443.2 VC Notice D'emploi page 51

j) Never use the lawn mower with damaged
safety devices or protective grilles or without
attached safety devices, e.g. deflectors
and/or grass-catching units.
k) Exercise care when starting or pressing the
starting switch and observe the manufactur‐
er's instructions. Ensure that you keep your
feet far enough away from the cutting
blade(s).
l) The lawn mower must not be tilted when
starting it, unless the lawn mower needs to
be lifted during the process. In this case, only
tilt it as far as is absolutely necessary and
only raise the side facing away from the
user.
m) Do not start the motor when you are standing
in front of the discharge chute.
n) Never put hands or feet on or underneath
rotating parts. Always keep away from the
discharge opening.
o) Never lift or carry a lawn mower with the
motor running.
p) Stop the motor and pull out the starting key.
Ensure that all moving parts have come to a
complete stop:
– whenever you leave the lawn mower;
– before remedying blockages, including
those in the discharge chute;
– before checking, cleaning or working on
the lawn mower;
– after hitting a foreign object. Inspect the
lawn mower for damage and perform the
necessary repairs before re-starting and
using the lawn mower.
If the lawn mower begins to vibrate exces‐
sively, it must be checked immediately.
– Check for damage;
– make the necessary repairs to damaged
parts;
– ensure that all screws, pins and bolts are
tightly fastened.
28.5 Maintenance and Storage
a) Ensure that all nuts, pins and bolts are tightly
fastened and that the machine is in a safe
working condition.
b) Check the grass-catching unit regularly for
wear or loss of functionality.
c) In the interests of safety, replace all worn or
damaged parts.
d) Be aware that on machines with more than
one cutting blade, the movement of one cut‐
0478-131-9948-D
ting blade can cause the other cutting blade
to turn.
e) Ensure when adjusting the machine that your
fingers do not become pinched between
moving cutting blades and stationary parts of
the machine.
Allow the motor to cool down before storing
f)
the machine.
g) Note when maintaining the cutting blades
that the cutting blades can be moved even if
the power source is switched off.
h) In the interests of safety, replace all worn or
damaged parts. Only use genuine spare
parts and accessories.
Table des matières
1 Préface......................................................52
2 Informations concernant la présente Notice
d'emploi.....................................................52
3 Vue d'ensemble........................................ 53
4 Prescriptions de sécurité...........................54
5 Préparation de la tondeuse.......................60
6 Recharge de la batterie et DEL.................61
7 Activation et désactivation de l'interface
radio Bluetooth®....................................... 61
8 Assemblage de la tondeuse à gazon........61
9 Réglage de la tondeuse pour l'utilisateur.. 62
10 Introduction et extraction de la batterie.....63
11 Insertion et retrait de la clé de sécurité..... 63
12 Mise en marche et arrêt de la tondeuse à
gazon........................................................ 64
13 Contrôle de la tondeuse et de la batterie.. 64
14 Utilisation de la tondeuse..........................66
15 Après le travail.......................................... 67
16 Transport...................................................67
17 Rangement............................................... 68
18 Nettoyage..................................................68
19 Maintenance............................................. 69
20 Réparation................................................ 70
21 Dépannage............................................... 70
22 Caractéristiques techniques......................72
23 Pièces de rechange et accessoires.......... 74
24 Mise au rebut............................................ 74
25 Déclaration de conformité UE................... 74
26 Déclaration de conformité UKCA.............. 75
27 Adresses................................................... 76
28 Prescriptions de sécurité pour les tondeu‐
ses............................................................ 76
1 Préface
Chère cliente, cher client,
français
51