CAME G2500N Manuel D'installation page 34

Activating the radio control
Connect the RG58 cable antenna cable to the corresponding terminals .
 For TOP and TAM-series transmitters operating on the 433.92 MHz frequency, set the AF card jumper shown in the figure .
Fit the AF card into the control board connector .
⚠Before fitting the AF card, you MUST CUT OFF THE MAIN POWER SUPPLY and, remove any emergency batteries.
TOP TAM


AF card

Keep pressed the PROG programming button on the control board. The programming LED flashes.
Press any key on the transmitter you want to memorize. The LED stays on to indicate that memorization has been successful.
 
Intermittent LED LED on
PROG LED
Radio card