Battery / Fuse Replacement; Repair - Amprobe AM8C Mode D'emploi

Battery / Fuse Replacement

To prevent electrical shock hazard, turn off the
multimeter and any device or circuit under test and
disconnect the test leads before removing the rear
cover.
. Remove the rear case by unscrewing the screws that secure it
to the front.
2. Fuse replacement: Remove the blown fuse (5 x 20mm) from
the fuse holder. Replace with a 200 mA/250 V quick acting
fuse (Amprobe PN: FP50A).
3. Battery replacement: Remove the .5 VDC AA battery and
replace with same.
4. Reassemble the instrument.
Use of an incorrect fuse could result in serious injury
or even death. Failure to turn off the multimeter
before installing the battery could result in damage
to instrument and battery.

Repair

All test tools returned for warranty or non-warranty repair or
for calibration should be accompanied by the following: your
name, company's name, address, telephone number, and proof of
purchase. Additionally, please include a brief description of the
problem or the service requested and include the test leads with
the meter. Non-warranty repair or replacement charges should be
remitted in the form of a check, a money order, credit card with
expiration date, or a purchase order made payable to Amprobe®
Test Tools.
In-Warranty Repairs and Replacement – All Countries
Please read the warranty statement and check your battery before
requesting repair. During the warranty period any defective test
tool can be returned to your Amprobe® Test Tools distributor for
an exchange for the same or like product. Please check the "Where
to Buy" section on www.amprobe.com for a list of distributors near
you. Additionally, in the United States and Canada In-Warranty
repair and replacement units can also be sent to a Amprobe® Test
Tools Service Center (see below for address).
� Warning
� Warning
6