Product Maintenance; Cleaning; Troubleshooting; Battery And Fuse Replacement (See Figure 14) - Amprobe 5XP-A Mode D'emploi

PRODUCT MAINTENANCE

Cleaning

To clean the meter, use a soft cloth moistened with water. To
avoid damage to the plastic components do not use benzene,
alcohol, acetone, ether, paint thinner,lacquer thinner, ketone
or other solvents to clean the meter.

Troubleshooting

If the meter appears to operate improperly, check the
following items first.
1. Review the operating instructions to ensure the meter
is being used properly.
2. Inspect and test the continuity of the test leads.
3. Make sure the battery is in good condition. The low
battery symbol
below the level where accuracy is guaranteed.Replace
a low-battery immediately.
4. Check the condition of the fuses if the current ranges
operate incorrectly.
Battery and Fuse Replacement
�
Warning
To avoid electrical, shock remove the test leads from both
the meter and the test circuit before accessing the battery or
thefuses.
To replace the fuse:
1. Remove the 2 rear-case screws.
2. Separate the case.
3. Remove and replace the 2 A fuse (15XP-B or 35XP-A)
or 0.315 fuse (5XP-A).
4. Reassemble the meter.
appears when the battery falls

11
(See Figure 14)