Pulsar AXION XM30S Instructions D'utilisation page 4

COMPONENTS AND CONTROLS
1. Eyepiece dioptre adjustment ring
2. Down/Rec button
3. Menu button
4. Up/Zoom button
5. On/Calibration ON button
6. Lens focus ring
7. Lens cap
8. MicroUSB connector
9. Battery release button
LED indicator displaying current status of the device
LED Indicator Operating Mode
Device is powered on
Device on / video recording
Device on / battery charge <10%
Device on / video recording / battery charge <10%
For a better viewing experience, we recommend
that glass wearers fold back the edge of the
elastic eyeshade.
BUTTON OPERATION
Device status / current First short press
device operating mode
ON button Device is powered off Power on the device
Display off Turn on display
Device turned on, quick Device calibration
menu, main menu
Up/Zoom Device is powered on Operating modes
button
Quick menu Increase parameter
Main menu Navigation up, right
Menu Device is powered on Open quick menu
button
Quick menu Navigation up
Main menu Confirm value, enter menu options
Down / Rec Device on / video mode Start video recording
button
Device on / video mode Pause
/ recording on
Device on / photo mode Photographing
Quick menu Reduce parameter
Main menu Navigation down, left
6 5 4 3 2 1
LED indicator
7 9 8
www.tulon.ru
Next short press Long press
Device calibration Power on the device
Device calibration Power off the device
Display off / device powered off
Change magnification (zoom)
Increase parameter
Navigation up, right
Open main menu
Exit quick menu
Exit menu options, exit main
menu
Pause Toggle video / photo mode
Start video recording Stop video recording
Toggle video / photo mode
Reduce parameter
Navigation down, left
USING THE RECHARGEABLE BATTERY
AXION thermal imagers are supplied with a
rechargeable APS3 Lithium-ion Battery Pack. The
battery should be charged before first use.
Charging the battery
Option 1 :
Install the battery (10) into its slot on the instrument
џ
case (14) by aligning the icons to form a 'dot' on the
device and the battery.
Attach a USB cable (15) to the microUSB connector
џ
(8) on the device.
Fig.
1
Connect the other end of the USB cable (15) to the
џ
mains charger (16) or to a USB socket connected to
another power source with rated output of 5V or less.
Connect the mains charger (16) to the mains power
џ
supply.
Note: The PB8I Power Bank may be used as a charger.
Option 2:
Insert the rechargeable battery (10) supplied with
џ
your device, or purchased separately, fully along the
guide rail into the APS charger slot (11).
Point A on the battery and Point B on the charger
џ
should be aligned.
Two batteries can be charged at the same time – a
џ
second slot is provided for this.
Attach the microUSB plug of the USB cable (15) to the
џ
socket (12) of the battery charger (11).
Attach the second plug of the USB cable (15) to the
џ
USB port on the mains adapter (16). Plug the device
into a 100 – 240 V socket (17).
The LED indicator (13) will light up the battery charge
џ
status (see table).
2