Publicité
Les langues disponibles
Les langues disponibles
9. While operating under extremely low temperature, let the log splitter run under no load for 15
minutes to preheat the hydraulic oil
10. Reminder: The log splitter is strictly designed for one-man operation. Never allow more than one
person approach and work on the machine at the same time.
5.4- Placing the log on the splitter
Prepare the wood to be split by pre-cutting it to the maximum cutting capacity of the splitter and
make sure that the wood is cut straight.
Put the wood on the splitter so as not to endanger you (e.g. tripping hazard).
a) Place the log vertically and sitting flat onto the support
table. Be sure the wedge and support table will contact the log
squarely on the ends. Never attempt to split a log at an angle
(Fig. 11b).
b) Adjust the Log Holders Claws (A) according to the
diameter of the log to obtain most comfortable Control Levers
angle (Fig.11a).
Fig.11a
c) Hold the log with clamping brackets closely in the control lever guards (Fig.11a).
d) Never open clamping brackets while ram is moving (Fig.11a)
OK
NO
NO
Fib. 11b
5.5- Starting the log splitter
Switch on: Press the green button (I).
Switch Off: Press the red button (0).
Never use the machine if the On/Off switch is not working properly.
Immediately have any damaged switch repaired or replaced by qualified
personnel to avoid a danger.
Fig. 12
Page 33 / 55
Publicité
