Publicité
Les langues disponibles
Les langues disponibles
(*) Example on how to upack the log splitter - Take the following steps 1 to 5:
Remove product from its packaging and follow the 5 steps illustrated in Fig.1.
- Put the Log Splitter on the ground by tipping every side of the carton by 45 degrees (turn the carton
to its 4 sides to successively open the 4 flaps).
- Make sure to put box (B) to support the Log Splitter box (A) at a point a little higher than the middle.
- The other side of box (B) shall be against steady object, such as a wall.
- A wedge (C) shall be arranged under the tipped Log Splitter Package (A) to avoid slipping.
- Then remove the carton off the Log Splitter (Fig.4e).
Fig.1a
Fig.1d
Check that product and accessories are not damaged.
4.2- Set up and preparation for operation
- Check that the machine is completely and correctly assembled according to local regulations.
- Make sure that no parts are missing. If one (or more) part(s) is (are) missing, do NOT use the splitter.
Contact your local dealer to obtain the missing parts and make sure to correctly assemble them before
using the machine. Failure to do so may result in serious injury.
- Before using the machine, make sure each time that
there are no faulty connections (tears, cuts, etc.)
there is no damage to the machine
all screws are tight
check the hydraulic system for any possible leaks, refill oil if necessary
- Ensure that the working area meets the following conditions:
no danger of slipping
level
free of obstacles
sufficiently well lit
- Do not operate the machine in the direct vicinity of gas or petrol pipes or containers, or any other
easily inflammable materials.
4.2.1- Wheel assembly (Fig.3)
- Assemble the wheels on each side with a washer and secure them with an R-pin.
4.2.2- Mounting the fixing plates (Fig.4)
- Insert the right fixing plate (A) into the rocker switch (B) and screw it with a hexagon bolt (C),
a washer and a safety nut. Tighten the nut so that the mounting plate can be moved.
- Repeat the same operation for the left fixing plate.
- Fit the protection bars (D) on the two fixing plates using 2 Phillips screws (E) for each plate.
Fig.1b
Fig.1e
Fig.1c
Page 28 / 55
Publicité
