Check Fuel; Operation Instructions; Operation; Start - Zipper Maschinen ZI-STE3000IV Mode D'emploi

11.1.2 Check fuel

Place the machine on a firm and flat surface.
Open the fuel cap.
Check the fuel filter.
Never refuel without fuel filter!
Fuel must be unleaded gasoline
NEVER REFUEL IF THE ENGINE IS
RUNNING!!
11.2

Operation instructions

 Always place the machine on a firm and flat surface! No turning, tilting or moving
during the engine is running
 Always check oil and fuel level before starting
 Do not connect the appliance before the unit is running at full speed. Disconnect
the appliance before turning the unit off.
 Connected devices must be in perfect condition.
Keep the cable length to the consumer as short as possible.

11.3

Operation

11.3.1 Start

 Turn the fuel valve to position „ON"
 Switch the Engine-switch to position „I"
ON
 At cold start set the choke to position
„START".
At worm start (the engine was running and is
still warm) set choke to Position „RUN".
If the generator fails to start after 5 attempts,
pull choke to position "START" and try again.
 If the engine runs smoothly set choke to
position „RUN"
 Start the engine with the recoil starter:
Grip the handle and pill the recoil starter.
If the engine does not start, try again.
Normally start: 3-4 attempts
When starting with the recoil starter, the motor may recoil suddenly as it starts up,
resulting in hand injuries!
ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
ZI-STE3000IV
NOTICE
OPERATION
23