Remaining Risk Factors; Operation; Pre-Operation Check; Check Engine Oil - Zipper Maschinen ZI-STE3000IV Mode D'emploi

10.3

Remaining risk factors

Even if the machine is used as required it is still impossible to eliminate certain residual risk factors
totally. The following hazards may arise in connection with the machine´s construction and design:
 Risk of burns:
Touching the mufflers, exhaust and other machine components which can be hot after prolonged
continuous operation or when the engine is hot cause severe burns.
 Risk of fire and explosion:
Gasoline is highly flammable and explosive under certain conditions.
NEVER refuel fuel or engine oil while the machine is in operation or is hot.
When refueling and at places where fuel is stored not smoke or allow open flames or sparks.
Do not overfill the fuel tank and avoid the spillage of gasoline during refueling. If fuel is spilled make
sure the area is completely dry and cleaned before starting the engine.
Make sure that the filler cap is tightly closed again after refueling safely.
 Chemical risks
Never use or refuel a gasoline or diesel engine in a closed area without adequate ventilation.
Carbon monoxide emissions from the internal drive units of the engine can cause in confined spaces
through inhalation health effects and death. Therefore use the machine only in well-ventilated rooms or
outdoors in operation.
Liquid fuels can cause serious damage on the skin and the environment.
 Risk of electric shock
Direct electrical contact may cause electric shock.
Never touch the unit with wet hands. Provide adequate grounding.
 Hearing damage
A longer stay in the immediate vicinity of the running unit may cause hearing damage.
Wear ear protectors!
These risk factors can be minimized through obeying all security and operation instructions, proper
machine maintenance, proficient and appropriate operation by persons with technical knowledge and
experience.
In spite of all safety is and remains her healthy common sense and their corresponding technical
qualification / training for use of the machines most important safety factor!
11

OPERATION

Please check the product contents immediately after receipt for any eventual transport damage or
missing parts. Claims from transport damage or missing parts must be placed immediately after initial
machine receipt and unpacking before putting the machine into operation. Please understand that later
claims cannot be accepted anymore.
11.1

Pre-operation check

11.1.1 Check engine oil

The generator is delivered without engine oil and fuel!
See capture maintenance => engine oil change
ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
ZI-STE3000IV
ATTENTION
Engine oil 15W40 must be filled before first use!
OPERATION
22