Flex L810 Notice D'instruction D'origine page 20

Operating instructions
WARNING!
Before carrying out any work on the angle
grinder, always pull out the mains plug.
Before switching on the power tool
Unpack the angle grinder and check that
there are no missing or damaged parts.
Switching on and off
Brief operation without engaged
switch rocker:
Push the switch rocker forwards and

hold in position.
To switch off the power tool, release

the switch rocker.
Continuous operation with engaged
switch rocker:
Push the switch rocker forwards (1.) and

engage by pressing the front end (2.).
20
L 10-10 125, L 810 125, L 1001
To switch off the power tool, release

the switch rocker by pressing the rear
end.
NOTE
Following a power failure, the switched on
power tool does not restart.
Quick-release guard
WARNING!
When using the angle grinder for roughing
or cutting, never work without the guard.
Pull out the mains plug.

Loosen the clamping lever (a).

Adjust the guard.

Tighten screw (b) until the clamping lever

can just be clamped by hand.
Retighten the clamping lever.

A special quick-release cutting guard

must be used for cutting.