Publicité
Les langues disponibles
Les langues disponibles
Installation
● Both electric and mechanical installation must be carried out by specialised
personnel.
The electrical appliance is designed to be built into a work top with a thickness of 2-6
cm in the case of TOP installation; 2.5-6 cm in the case of FLUSH installation.
The minimum distance between the hob and the wall must be at least 5 cm in front, at
least 4 cm on the sides and at least 50 cm from overhead wall units.
NB = The recommended distances are given as examples: when planning the
spaces, the indications of the kitchen manufacturer must be observed.
Preparation of the hood for installation:
Before starting the installation:
•
After unpacking the product, check that it has not
been damaged during transport and in the event
of problem, please contact the reseller or the
Customer support service before installing it.
•
Check that the product is the right size for the
installation area.
•
Check for accessories (e.g. bags containing screws,
warranty certificates, etc.) inside the packaging
(placed there for transport reasons). Remove and
keep them safe, if present.
•
Also check that there is a power socket near the
installation area.
Preparing the cabinet for installation:
-
The product cannot be installed above cooling
appliances, dishwashers, heaters, ovens, washing
machines and dryers.
-
Create the cut-outs in the cabinet before inserting the
hob and carefully remove any shavings or sawdust.
Caution! Failure to install screws and
fasteners in accordance with these
instructions may result in electrical
hazards.
Note: to ensure the correct installation of the product, it is
recommended to tape the pipes using an adhesive with
the following characteristics:
- soft elastic PVC film, with an acrylic-based adhesive
- compliant with DIN EN 60454 regulations
- flame retardant
- excellent resistance to wear
- resistant to temperature fluctuations
- can be used at low temperatures
IMPORTANT:
use a single-component adhesive sealant
(S), which withstands temperatures up to 250°; before
installation, thoroughly clean the surfaces to stick and
eliminate any substance that may compromise
adhesion, (e.g. release agents, preservatives, fats, oil,
dust, traces of old adhesives, etc.); the adhesive
should be uniformly spread all around the outside of
the frame; after sticking, leave the adhesive to dry for
about 24 hours.
Fig. 1b
4-Wire Cable from Home Power Supply to
4-Wire Cable from Cooktop
IMPORTANT: Use the 4-wirw cable from
home power supply in the U.S. where local
codes do not allow grounding through homes
and recreational vehicles, new construction,
and in Canada
A. Cable from home power supply
B. Black wires
C. Green or yellow-green ground wires
D. 4-wire cable from cooktop
E. Junction box
F. White wires
G. UL listed wire connector
H. red wires
I. UL listed or CSA approved conduit
connector
13
Publicité
