Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
The sophisticated design of your FLAVIA® Brewer makes it very unlikely that anything will go wrong.
However, if faults do develop, you can resolve many of them yourself.
Please refer to the icons on the consumer interface detailed on page 3
"Flashing" = ON:OFF pulsing
"Blinking" = Slower ON:OFF pulsing
•
'CALL OPERATOR'
priming instructions.
•
'CALL OPERATOR'
please call your local customer service office.
•
'CALL OPERATOR'
please call your please call your local customer service office.
•
'HOURGLASS'
local customer service office. Note: If your drinks station has been stored in an extreme cold
servic
environment, and his error appears, please leave switched off in a normal ambient for 12hours and
then switch on.
•
'ADD WATER'
then please check that the mains water supply is turned on and press any button to re-attempt to
fill the Brewer. If the problem persists then please call your local customer service office
.
•
'INSERT/REMOVE PACK'
that no filterpacks have been inserted. The priming cycle is being inhibited because a pack is
present or the pack door is open.
•
'INSERT/REMOVE PACK'
•
'DOLLAR SIGN'
category
•
'DOLLAR SIGN'
T R O U B L E S H O O T I N G
& 'HOT WATER' button flashing - hot tanks need priming: Ref page 5 for
& 'HOURGLASS'
flashing on its own - other fatal error: turn your drinks station off and
flashing for more than 80 secs: turn your drinks station off and please call your
flashing for more than 60 secs when plumbed in: If the Brewer is plumbed in
flashing on its own: If in priming mode (ref page 5) please ensure
been
blinking on its own – Brewer in energy-saving standby mode.
flashing for 4 secs after pressing a category button - insufficient credit for that
flashing at any other time - some coin credit, but not enough for a 1-pack vend
- main boiler fault: turn your drinks station off and
15
Publicité
Table des Matières
